Tried installing 32bit & 64bit LXDE today from pendrives.
I did not bother with 'Use Entire Disk' as we know that works.
Zeroed out the mbr, Using 'Create Partition With Preset Mountpoint', created a new GPT table, then created a 10gb slice & selected it. Filled in the root & user info, hit 'Forward' & got sent back to the Install Start Screen, went forward again from there, & after filling in the root & user info, it crashed. (!)
Restarted the installer, selected 'Custom', selected my 10gb slice, used the auto partitioning (/ & swap), installation started.
However, my 'Installation' window showed no activity whatsoever - I only knew it was installing because my LED on the pendrive was flashing. It did install OK.
(For anyone else reading this, I had a size of 8.3gb, used 3.8gb, free 3.9gb.)
Using 'Create Partitioning With Preset Mountpoint', it suggested P1 freebsd-boot 256kb, P2 freebsd-ufs 8,734mb, P3 swap 229,740mb (!!!!). So I promptly deleted the recommended 'swap'. Filled in the root & user info, got the installer screen,& then 'Installation Error' screen.
(This forum does not seem to allow file attachments.)
sysinstall error log :-
kern.geom.debugflags: 0 -> 16
Running gpart on /dev/ada0
Running: gpart delete -i 3 /dev/ada0
gpart: index '3': No such file or directory
EXITERROR: Error 1: gpart delete -i 3 /dev/ada0
kern.geom.debugflags: 16 -> 16
Running gpart on /dev/ada0
Running: gpart delete -i 2 /dev/ada0
Running: gpart add -s 512 -t freebsd-boot /dev/ada0
Stamping pmbr sector on /dev/ada0
Running: gpart bootcode -b /boot/pmbr /dev/ada0
bootcode written to ada0
Running: gpart add -s 7226M -t freebsd-ufs /dev/ada0
Running: gpart add -t freebsd-swap /dev/ada0
Running: gpart bootcode -p /boot/gptboot -i 1 /dev/ada0
NEWFS: /dev/ada0p2 - UFS+SUJ
Running: newfs -U /dev/ada0p2
/dev/ada0p2: 0.2MB (512 sectors) block size 32768, fragment size 4096
using 1 cylinder groups of 0.25MB, 8 blks, 128 inodes.
with soft updates
super-block backups (for fsck_ffs -b #) at:
first cylinder group ran out of space
EXITERROR: Error 39: newfs -U /dev/ada0p2
Next I tried 'Create Partition With Preset Mountpoint' again but this time I deleted all suggested partitioning, created a 10gb slice, selected that, filled in the root & user info, got the installation screen, & it proceeded to install OK.
Rebooted into my new installation, deleted the wifi sysinstall auto section of /etc/rc.conf, ran the wifi manager & got wifi working this time without having to do any manual config.
So my conclusions are, the installer works OK, but is somewhat confusing, especially to a Linux user.
Edit: I shall now try & put this into a very basic 'howto'.
Linux user since 1999; & now a BSD user.